Haier GE UAWB46A Installation Instructions

Before you begin installation, read these instructions completely and carefully.Observe all governing codes and ordinances as they may apply.Leave these instructions with the owner

IMPORTANT SAFETY NOTICE
To avoid personal injury or property damage, this accessory is to be installed only by a licensed and trained industry professional. The manufacturer will not assume liability for unqualified installers or failure to follow these instructions.

WARNING
For personal safety, disconnect system power before installing this accessory.During installation, if ground wires, screws, straps, clips, or other means of attaching groundingcomponents are removed, they must be returned to their original positions and fastened securely.

Model: UAWB46A

Parts Included:

  • Wind baffle (2 parts)
  • 8 stainless self-tapping screws
  • 4 screw covers
  • This instruction sheet
    uawb46ba.png

Step 1:
Remove top screws from grille, slide the windbaffle behind and replace the factory screws.
step1.jpg

Step 2:
On some models, the grille screws can be usedin the same manner as the top. Use the sup-plied screws if needed.
step2.jpg
Step 3:
Drive 3 screws through the front of the wind baffle where the two pieces overlap. This willeliminate any vibration rattle during operation. Cover the ends of the screws with the suppliedcaps to prevent any injury when reaching down between the baffle and the grille.
step3.jpg

Note: This Installation Guide is adapted from the official manual created by Haier in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline