LFLED4LV INSTALLATION INSTRUCTIONS

Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
lfled4lv.jpg

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is requiredfor safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSONFAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

⚠️ WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.

⚠️ WARNING: MAX 12VAC ONLY.

⚠️ WARNING: Suitable for wet locations. Suitable for mounting within 1.2m (4ft) of the ground.

WALL MOUNTING

Mount to a weatherproof junction box and cover plate (notsupplied) as shown. To ensure weatherproof seal, applyweatherproof silicone sealant around the edge of the wallcover plate or surface box. This is especially important withan uneven wall surface.

  1. Seal arm thread using Teflon tape or silicone sealant.
  2. Thread fixture into Cover Plate(not supplied).
  3. Connect wires as shown in the wiring diagram.4. Attach cover plate to Junction Box (not supplied).5. Aim floodlight in the direction desired and tightenlocknut and Arm Screw.

lfled4lv2.jpg

GROUND MOUNTING

Mount to a Mighty Post (RAB Cat# MP19) as shown.

  1. Thread fixture into Mighty Post Cap.
  2. Connect wires as shown in the wiring diagram and placeinside the Mighty Post.
  3. Place Mighty Post Cap on the Mighty Post.
  4. Aim floodlight in the direction desired and tightenlocknut and Arm Screw
    lfled4lv3.jpg

WIRING

The driver permits operation only at 12 VAC. Wire LFLED4LV using approved wiring devices for SPT-1 cord.

lfled4lvwiring.jpg

CLEANING & MAINTENANCE

CAUTION: Be sure fixture temperature is cool enoughto touch. Do not clean or maintain while fixture isenergized.

  1. Clean glass lens & fixture with non-abrasive glasscleaning solution.
  2. Do not open fixture to clean the LED. Do not touch theLED.

TROUBLESHOOTING

  1. Check that the voltage at fixture is correct. Refer to wiringdirections.
  2. Keep leaves and debris out of hood.

ACCESSORIES

Reflector door lens kit can be ordered separately

LNSLFLED815° spot reflector, door, lens kit for LFLED4LV
LSLFLED820° spot reflector, door, lens kit for LFLED4LV
Note: This Installation Instructions is adapted from the official manual created by RAB Lighting in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline