INSTRUCTIONS

Camera Control Unit

Before installing and using the unit, please read these instruction carefully. Be sure to keep it handy for later reference.
This unit is conceived to be connected between a camera (sold separately, and with MENU function) and its peripheral devices (such as a multiplexer, a timelapse VCR, a monitor TV, etc.) in order to control and set the camera’s menus remotely.

PRECAUTIONS

  • Do not use the unit if smoke or a strange odour comes from the unit, or if it seems not to function correctly.
  • Do not open the cabinet, as it may be dangerous and cause damage to the unit. For internal settings and repairs, consult your dealer (or a Sanyo Authorized Service Centre).

PARTS NAMES

vac60-part-names.png

  1. Video signal output terminal (VIDEO OUT)
  2. Camera signal input terminal (CAMERA)
  3. Power switch (POWER ON/OFF)
  4. Menu setting button (SET)
  5. Battery compartment
  6. Cursor button (CURSOR)
    🔺 Press this button to move the cursor up.
    ▶️: Press this button to move the cursor to the right, or to turn the
    settings ON/OFF etc.
    ◀️: Press this button to move the cursor to the left, or to turn the
    settings ON/OFF etc.
    🔻: Press this button to move the cursor down

INSERTING THE BATTERIES

  1. Press the catch and remove the cover from the battery compartment.
  2. Insert the batteries (Manganese or Alkali type, AAA, 2 x 1.5 V). Observe the polarity marks on the bottom of the battery compartment.

Disposal of old batteries

SANYO recommends that you do not dispose of used batteries with domestic refuse. Please, contact your dealer or your local authorities for information regarding the disposal of used batteries or take them to your nearest collection point.

CONNECTIONS AND OPERATION

  1. Connect this unit between the camera and the peripheral devices, as illustrated below. Then, turn on all the devices.
  2. Set the unit POWER switch to the ON position.
  3. You can now use the CURSOR (◀️, ▶️, 🔺 or 🔻) buttons and the
    SET button to control and set the camera’s menus.
    For each camera menu settings details, please refer to the
    concerned camera instruction manual.

NOTE: This unit is only used for easy setting of the camera(s). Once the settings have been made, please turn off and disconnect the unit.

vac60-connection.png

SPECIFICATIONS

Video output terminalBNC connector x1
Camera input terminalBNC connector x1
Power3V DC, 2 AAA format batteries
Operating environmentTemperature (–10 to 50˚C)
Humidity (10 to 80 %)
Dimensions90 (W) x 35 (H) x 135 (D) mm
WeightApprox. 230 g (without batteries)

Features and specifications are subject to change without prior notice or obligations.

Note: This Instruction Manual is adapted from the official manual created by Sanyo in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline