jubilee

Roaring like a British Lion from Wembley to the Sunset Strip, the Jubilee is ready to melt faces. Sure, it can do subtle but that’s no fun. Crank it up and rock out.


The Jubilee Silver Overdrive is based on the classic Pharaoh Amplifiers pedal of the same name. These pedals were produced in a very limited number and were all sold to our dealer in Japan. We’ve kept the circuit the same, and managed to cram the whole pedal in a much smaller enclosure. Add in our celebrated relay based soft-touch switching and you get the new Jubilee Silver Overdrive.

jubilee-silver-overdrive

Controls:

LOUDNESS – Controls the output volume of the boost. Crank it to overdrive your tube amp.
DRIVE – Adjusts the gain and distortion of the pedal.
TREBLE, MIDDLE, BASS – Passive three-band tone stack, voiced like a British amplifier.

Bypass Switching:

The Jubilee features true bypass switching using a latching relay and a soft-touch bypass footswitch. The Jubilee will power on in either bypass mode or effect mode (useful if you are using the pedal with a remote bypass switching system.) Hold the footswitch at boot to toggle between bypass and effect startup modes. The pedal remembers your settings when the power is removed. The Jubilee is fully analog.

Power Supply:

The Jubilee requires a DC power supply with a 2.1mm pin, center negative. The Jubilee will operate on power supply voltages up to 18V and does not use a battery. The Jubilee should work fine on a multi-pedal “daisy chain” connector, but if you encounter excessive noise or hum try a separate power supply. The Jubilee requires approx. 12mA.


alexander
GREAT TONES. DOING GOOD.
404 E. Main St, Garner, NC 27529 (919) 977-6665 alexanderpedals.com

Note: This User's Manual is adapted from the official manual created by Alexander Pedals in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline