Table of contents

dusky-electronics

More Me

User’s Manual


INTRO

You are now the lucky owner of a More Me pedal from Dusky Electronics. That’s awesome!
We’re happy to have our original design and unique sound on your pedal board.
The More Me is a boost pedal, so it makes your signal louder, obviously. It’s clean. But it’s not super clean. It’s single MOSFET design adds some harmonic distortion. It has a frequency response that has been gently tweaked to emphasise midrange frequencies. The idea is that working in conjunction with your amplifier, it can be an additional gain stage. Use it to get a little louder when you need it, or use it with an amp close to breakup to send it the rest of the way there. You know, for when you just need a little “more me”.

CONTROL

The single control knob controls the output volume. Clockwise is louder. At maximum, More Me provides about 20db of gain. The more you crank it, the more likely you are to induce distortion in some device connected downstream, such as your amplifier, or another dirt pedal. Season to taste.

POWER

More Me may be powered from an internal 9V battery or from an external power supply. The 9V battery is accessed by removing the four screws that hold on the bottom plate of the pedal.
More Me can be powered from any power supply intended for use with pedals, which has a negative tip (the standard) and provides DC voltage anywhere from 9 to 18 volts. You might notice More Me has a bit more headroom and is a little louder on 18V. It can’t hurt to experiment and see if you have a preference.

Note: This User's Manual is adapted from the official manual created by Dusky Electronics in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline