Fender Compugilist Manual

compugilist.png

  1. Distortion Bypass Footswitch & LED
  2. Output Jack
  3. Level (Distortion)
  4. Tone
  5. Gain
  6. Bass Boost
  7. Recovery
  8. Compression
  9. Level (Compressor)
  10. Gain Reduction LED
  11. Input Jack
  12. Compressor Bypass Footswitch & LED
  13. Low Battery Indicator
  14. LED Kill Switch
  15. DC Power Connector

Thanks for purchasing Compugilist – a versatile new dual-effect unit based on two of our most popular pedals: The Bends Compressor and Pugilist Distortion. Both effects are independently switchable and feature straightforward controls.
The Compressor offers Recovery, Compression and Level controls, with a Gain Reduction indicator light. The Distortion side offers familiar Gain, Tone and Level controls.
The Compugilist is a great way to get that classic “mastered” rock tone in a single pedal.

DESIGNED IN CALIFORNIA, U.S.A.

Distortion Bypass Footswitch & LED

Footswitch bypasses distortion effect. LED Illuminates when distortion
effect is active.

Level (Distortion)

Controls overall distortion output level.

Tone

Similar to tone control on a guitar — turn counterclockwise to decrease
treble frequencies; turn clockwise for full-range tone.

Gain

Controls amount of distortion added to signal.

Bass Boost

Boosts low-end frequencies.

Compressor Bypass Footswitch & LED

Footswitch bypasses compressor effect. LED Illuminates when
compressor effect is active.

Recovery

Controls compressor recovery time.

Compression

Controls amount of compression (compression ratio).

Level (Compressor)

Controls overall compressor output level.

G.R. (Gain Reduction) LED

Illuminates when gain is actively being reduced.

Input Jack

High-impedance input suitable for electric guitar, bass, acoustic guitars
with pickup systems, keyboards and other instruments.

Output Jack

Low-impedance output jack connects to amp or to next effect pedal in
signal chain.

DC Power Connector

Standard center-negative 9VDC jack for use with appropriate power
supplies.

LED Kill Switch

Deactivates control-knob illumination


A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORPORATION
CORONA, CALIFORNIA, USA
Fender® is a registered trademark of FMIC.
Copyright © 2019 FMIC. All rights reserved.
P/N 7717097000 – REV 1

Important Safety Instructions

  • WARNING: To prevent damage, fire or shock hazard, do not expose the unit or its AC power to rain or moisture.
  • Do not alter the AC plug of the connected power adapter
  • Do not drip or splash liquids on the unit.
  • No user serviceable parts inside, refer servicing to qualified personnel only.
  • WARNING: The unit must only be connected to a safety agency certified, regulated, power source (adapter), approved for useand compliant with applicable local and national regulatory safety requirements.
  • Unplug the AC power adapter before cleaning the unit exterior. Use only a damp cloth for cleaning and then wait until the unit is completely dry before reconnecting it to power.
  • Amplifiers and loudspeaker systems, and ear/headphones (if equipped) are capable of producing very high sound pressure levels which may cause temporary or permanent hearing damage. Use care when setting and adjusting volume levels during use.

Additional Languages

Manual available in additional languages at:
www.fender.com/support

Specifications

IMPEDANCES:INPUT: 820kΩ OUTPUT: <6kΩ
POWER SUPPLY:One 9V battery or 9VDC regulated adapter,
5.5 x 2.1 mm barrel connector, center negative
POWER REQUIREMENTS:75mA @ 9VDC
DIMENSIONS:3.75” x 4.9” x 2.5” (95.25mm x 124.5mm x 63.5mm)
WEIGHT:1.2lbs (.54kg

Product specifications subject to change without notice

Note: This User's Manual is adapted from the official manual created by Fender in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline