mtg-la.png

  1. Bypass Footswitch
  2. Jewel Indicator
  3. Output Jack
  4. Level
  5. Tone
  6. Treble
  7. Boost Level
  8. Boost LED
  9. Boost
  10. Bass
  11. Tight
  12. Gain
  13. Input Jack
  14. Boost Footswitch
  15. LED Kill Switch
  16. DC Power Connector

Fender MTG: LA

Thanks for purchasing MTG: LA – a high-gain tube distortion pedal inspired by the late ’80s sounds of the Sunset Strip. MTG: LA uses a real NOS 6205 preamp tube running at 150 plate volts for authentic tube tone. You’ll find familiar Level, Gain, Tone and EQ controls, and a footswitchable boost that can be configured to add volume or even more gain.

DESIGNED IN CALIFORNIA, U.S.A.

Bypass footswitch

Bypasses effect.

Jewel indicator

Illuminates when effect is active.

Level

Controls overall distortion output level.

Boost Level

Controls output volume.

Boost LED

Illuminates when boost is engaged.

Boost

Controls amount of saturation added to signal.

Gain

Controls amount of distortion added to signal.

Tone

Similar to tone control on a guitar — turn counterclockwise to decrease
treble frequencies; turn clockwise for full-range tone.

Treble

Controls high-frequency boost/cut.

Bass

Controls low-frequency boost/cut.

Tight

Helps control low-end tonal characteristics that can make higher-gain
settings sound muddy or unclear.

Input Jack

High-impedance input suitable for electric guitar, bass, acoustic guitars
with pickup systems, keyboards and other instruments.

Output Jack

Low-impedance output jack connects to amp or to next effect pedal in
signal chain.

DC Power Connector

Standard center-negative 9VDC jack for use with appropriate power
supplies.

LED Kill Switch

Deactivates control-knob illumination.


A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORPORATION
CORONA, CALIFORNIA, USA
Fender® is a registered trademark of FMIC.
Copyright © 2019 FMIC. All rights reserved.
P/N 7717098000 – REV 2

Important Safety Instructions

  • WARNING: To prevent damage, fire or shock hazard, do not expose the unit or its AC power to rain or moisture.
  • Do not alter the AC plug of the connected power adapter
  • Do not drip or splash liquids on the unit.
  • No user serviceable parts inside, refer servicing to qualified personnel only.
  • WARNING: The unit must only be connected to a safety agency certified, regulated, power source (adapter), approved for useand compliant with applicable local and national regulatory safety requirements.
  • Unplug the AC power adapter before cleaning the unit exterior. Use only a damp cloth for cleaning and then wait until the unit is completely dry before reconnecting it to power.
  • Amplifiers and loudspeaker systems, and ear/headphones (if equipped) are capable of producing very high sound pressure levels which may cause temporary or permanent hearing damage. Use care when setting and adjusting volume levels during use.

Additional Languages

Manual available in additional languages at:
www.fender.com/support

Specifications

IMPEDANCES:INPUT: 500kΩ OUTPUT: 100Ω
POWER SUPPLY:One 9V battery or 9VDC regulated adapter,
5.5 x 2.1 mm barrel connector, center negative
POWER REQUIREMENTS:2690mA @ 9VDC
DIMENSIONS:3.75” x 4.9” x 2.5” (95.25mm x 124.5mm x 63.5mm)
WEIGHT:1.2lbs (.54kg

Product specifications subject to change without notice

Note: This User's Manual is adapted from the official manual created by Fender in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline