JHS 3 Series Flanger

CONTROLS

BLEND – This control blends in the flanger effect over your clean signal. Turn knob right for increased flange and experiment with this knob in lower positions for “almost chorus” tones.

RATE – Controls the speed of the flange. Turning the knob clockwise increases the speed.

INTENSITY – Controls the amount of flange. Left is mild flanging, right is a more extreme flanging.

TAPE – Toggle up moves the sound into tape-like sweeps with zero through flanging. This mode is inspired by real tape flanging as done in studios by altering the speed of tape machines during playback

JACKS

INPUT – 1/4” jack on the right side of the pedal.

OUTPUT – 1/4” jack on the left side of the pedal.

POWER – Requires 9V DC negative center power and consumes 70mA. Do not use more than 9V DC. You will void your warranty.

Note: This User's Manual is adapted from the official manual created by JHS Pedals in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline