JHS 3 Series Phaser

The 3-Series Phaser is a versatile and easy to use six-stage phaser pedal that is inspired by the classic phaser circuits of the 1970s. It has all the standard phase tones you would expect, but because of its unique Blend control and Feedback toggle, you can achieve a wide range of modern and experimental tones.


CONTROLS

BLEND – Allows you to blend the wet and dry signals as you turn from left to right. All the way left is fully dry, all the way right is fully wet. Fully wet can achieve an almost vibrato effect.

RATE – Controls the speed of the LFO. Left is slower, right is faster.

WIDTH – Controls the width of the LFO. Left is more mild, right is more extreme.

FEEDBACK – Toggle up adds resonance to the effect by feeding the output back into the input, creating a more intense phase by emphasizing certain frequencies.

JACKS

INPUT – 1/4” jack on the right side of the pedal.

OUTPUT – 1/4” jack on the left side of the pedal.

POWER – Requires 9V DC negative center power and consumes 70mA. Do not use more than 9V DC. You will void your warranty.

Note: This User's Manual is adapted from the official manual created by JHS Pedals in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline