JHS 3 Series Reverb

CONTROLS

VERB – Controls the amount of reverb. Left is less, right is more.

EQ – Controls the overall tone of the reverb. Left is darker, right is brighter.

DECAY – Controls the length of the reverb trail. Left is shorter, right is longer.

PRE-DELAY TOGGLE – Switch up to create a short delay between the time the reverb starts and the original signal.

JACKS

INPUT – 1/4” jack on the right side of the pedal.

OUTPUT – 1/4” jack on the left side of the pedal.

POWER – Requires 9V DC negative center power and consumes 74mA. Do not use more than 9V DC. You will void your warranty.

Note: This User's Manual is adapted from the official manual created by JHS Pedals in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline