Table of contents

AT+

Andy Timmons’ signature channel drive and boost. British style overdrive and
distortion with a boost that will have your guitar singing like Andy’s!


CONTROLS

VOLUME – Controls the output volume.

DRIVE – Controls the amount of drive/gain just like a tube amp being cranked at high volumes.

EQ – High pass filter that naturally brightens or darkens the overall tone of the pedal. Right is brighter, left is darker.

AIR – Just like the presence knob on an amp, this allows you to dial in the perfect amount of high end for compatibility with any amp. Right is brighter, left is darker.

BOOST – Controls the volume of the independent boost circuit. Right is more, left is less.

TOGGLE – Gives you 25w/50w/100w feel. Up is 25w, down is 50w, and middle is 100w.

JACKS

INPUT – 1/4” jack on the right side of the pedal.

OUTPUT – 1/4” jack on the left side of the pedal.

POWER – Uses 9V to 18V DC Negative Center. This pedal CAN be run at 18V for more headroom and greater dynamics. Do not use more than 18V DC. Your warranty will be voided. 15mA consumption.

SWITCHES

AT BYPASS – Switch on the left side of the pedal.

BOOST BYPASS – Switch on the right side of the pedal

Note: This User's Manual is adapted from the official manual created by JHS Pedals in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline