Table of contents


Transparent low/medium gain overdrive that never gets in the way.
The overdrive you’ve always wanted but could never find.


VOLUME – Controls the output volume. Left is less, right is more.

DRIVE – Controls the amount of drive or gain just like a tube amp being cranked at high volumes. You will notice that as you turn up the drive, it also adds brightness. Left is less, right is more.

TONE – Controls the amount of brightness. Right is brighter, left is darker.

GAIN TOGGLE – Engages higher gain mode when flipped up. The LED will turn red to indicate that you are in the higher gain mode.

BRIGHT CUT SWITCH – Switch on the right side of the pedal that cuts the highest frequencies in case the overall tone is too bright.


INPUT – Lower 1/4” jack on the right side of the pedal.

OUTPUT – 1/4” jack on the left side of the pedal.

RED REMOTE JACK – The upper jack on the right side of the pedal is for a JHSRed Remote” switch.

When using this switch you can toggle between the higher gain mode and the standard mode on the fly.

POWER – Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided. 43mA consumption

Note: This User's Manual is adapted from the official manual created by JHS Pedals in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline