Table of contents

CLOVER

This classic FET preamplifier gives you tons of volume and powerful EQ to shape and boost your tone for an unforgettably lucky sound.Let the Bonsai help you find your overdrive zen.


CONTROLS

VOLUME – Controls the overall volume of the unit. You can set the volume at unity gain or use it to boost your signal.
EQ SELECTOR SWITCH – Select three different EQ types: Full EQ, No Mid, and No EQ. The No Mid setting gives you the same EQ settings as the original BOSS FA-1.
BASS – Controls the amount of bass in your signal. Left is less, right is more
MIDS – Controls the amount of mid frequencies in your signal. Left is less, right is more.
TREBLE – Controls the amount of treble in your signal. Left is less, right is more.
LOW CUT – Dip switch on the right side of the pedal that cuts low end.
GROUND LIFT – Dip switch on the left side of the pedal. When using the XLR output, if you experience a hum you can switch on the Ground Lift to remove the hum.

JACKS

INPUT – 1/4” jack on the right side of the pedal.
OUTPUT – 1/4” jack on the left side of the pedal.
XLR OUTPUT – XLR jack on the left side of the pedal. You can use this to go straight into a mixer or interface. The 1/4” output and XLR output can be used simultaneously.
POWER – Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided. 46mA consumption.

Note: This User's Manual is adapted from the official manual created by JHS Pedals in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline