Table of contents

JHS Pedals Crayon

British voiced preamp distortion, fuzz, overdrive, and boost in a versatile small footprint that follows in the shadow of the Colour Box.
Looking for a different dirt sound? Look no further.


CONTROLS

MASTER – Controls the output volume. Left is less, right is more.
PRE-VOL – Works as a drive or fuzz control like turning up the pre-volume on a preamp. As you reach 75% and above, the fuzz will begin to gate out when you pick the strings harder.
TILT – Active tone control that is flat when the knob is at 50%. When turned to the left, it will boost bass and simultaneously cut treble. When turned to the right, it boosts treble and cuts bass.
HI-PASS – Cuts your low end with a flick of the switch for the ability to cut through the mix or get lo-fi sounds.
DIP SWITCH – Allows for either 200Hz or 750Hz cut for the Hi-Pass.

JACKS

INPUT – ¼” jack on the right side of the pedal.
OUTPUT – ¼” jack on the left side of the pedal.
POWER – Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided.
15mA consumption.

Note: This User's Manual is adapted from the official manual created by JHS Pedals in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline