Table of contents

SUPERBOLT V2

Supro tones in a pedal and a whole lot more! This discreet circuit does everything from clean boost to sagging exploding small amp distortion with ease.
The word/name Supro is a registered trademark of Pigtronix. The JHS SuperBolt pedal is in no way affiliated with Supro® USA or Pigtronix.

CONTROLS

VOLUME – Controls the output volume.

DRIVE – Controls the amount of drive or gain just like a tube amp being cranked at high volumes.

TONE – Increases brightness. Right is brighter, left is darker.

GAIN TOGGLE – Engages higher gain mode when flipped up. The LED will turn red to indicate that you are in the higher gain mode.

JACKS

RED REMOTE JACK – The upper jack on the right side of the pedal is for a JHS “Red Remote” switch. Using this switch you can toggle between the higher gain mode and the standard mode on the fly.

INPUT – Lower jack on the right side of the pedal.

OUTPUT – Jack on the left side of the pedal.

POWER – Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be
voided. 3mA consumption.

Note: This User's Manual is adapted from the official manual created by JHS Pedals in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline