Table of contents

PG-14

The PG-14 is an end-all overdrive/distortion pedal for adding the ultimate dirt channel to your amplifier. A bonus feature is that it gives you all of Paul Gilbert’s talent, decades of experience, good looks, and countless years of practice.

CONTROLS

VOLUME – Controls the overall volume of the unit. Right is more, left is less.

DRIVE – Controls the amount of overdrive. Right is more, left is less.

PUSH – Push is how hard the input of the circuit is pushed. Essentially, it is a powerful preamp hitting the front of the “FET” amplifier. Right is more, left is less. This affects the drive control as well.

TONE – Controls the overall tone of your signal. Right is bright, left is dark.

MID – Controls the gain of the mid frequencies. Right is more, left is less.

MID FREQ – Selects the range of mid frequencies the MID knob controls from 400Hz to 7.5kHz. To the right is high-mids, to the left is low-mids.

JACKS

INPUT – 1/4” jack on the right side of the pedal.

OUTPUT – 1/4” jack on the left side of the pedal.

POWER – Uses 9V DC Negative Center. Do not use more than 9V DC. Your warranty will be voided.
36mA consumption.

Note: This User's Manual is adapted from the official manual created by JHS Pedals in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline