KLIQ Ultra-TinyTuner User Manual

Important

Please remove the plastic battery insulation sheet before using the tuner. TUNER WORKS OFF VIBRATION AND MUST BE CLIPPED ONTO THE INSTRUMENT TO WORK.

Get Started

  1. Slide open the Battery Cover
  2. Pay close attention to +/- terminals (insert 2 LR44 batteries [included])
  3. Slide closed the battery cover and switch on the Ultra-TinyTuner (UT2)
  4. If the display does not turn on, double check that the batteries are clean and the +/- orientation is correct
  5. When the screen becomes dim or the tuning indicator becomes slow, it is time to change your battery

Operation

  1. Clip your UT2 onto the headstock, soundboard, or other convenient vibrating point on your instrument. THIS TUNER WILL ONLY WORK WHEN CLIPPED ONTO A VIBRATING POINT
  2. Press and hold the Power button to turn on your UT
  3. Follow the display indicator (see back of the box) to zero-in on your note which will be shown in the center of the display
  4. The arrows will turn from Red (flat or sharp) to Green when you are in tune
  5. To save battery life, the display will automatically shut off after 10 minutes if there is no vibration detected.

Warning: Changes or modification not expressly approved by the manufacturer by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This User's Manual is adapted from the official manual created by Kliq Music Gear in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline