kliptonite.jpg

The Kliptonite Black Edition is a Ltd version of our original Kliptonite circuit boasting an updated gain stage on each of the fuzz and the overdrive channels as well as a more balanced volume between the two.
The Fuzz side is our Velcro Fuzz and the Overdrive side is our version of the Tube Sound Overdrive. In a unique concept where the signal is split inside the circuit and then mixed back together, this method gives you the ability to mix overdrive overdrive and fuzz in different different ratio‘s ratio‘s creating creating unique sounds. sounds.
We have taken this concept further by combining these elements with our parametric EQ which creates a generous array of tones for guitar and bass.
Compared Compared to the original original weve refined re the gain stages of both sides and balanced balanced out the volume differences differences to make it even better. better.

Please note:
You can adjust the bias of the pedal via the internal bias trim pot for more or less sustain. This product is intended to sustain much less than normal fuzz pedals as its specifically specifically called a velcro fuzz and is a very gated type of sound.

  • STEP 1: Open up the guitar pedal using the screws on the bottom of the unit.
  • STEP 2: Plug your guitar into the pedal and the pedal into your amp.
  • STEP 3: While playing an open chord, turn the bias trim pot in small increments until the tone either sustains or becomes more gated.

Please note at manufacture the pedal has been set to its maximum sustain.

kliptonite2.jpg

GENERAL INFO

  • Parametric EQ with adjustable fuzz and overdrive
  • Frequency response from 35Hz-6kHz (For Bass & Guitar)
  • Cut / Boost of plus / minus 20dB
  • Mirror Mix feature for mixture of both overdrive and fuzz tones
  • Frequency sweep control via expression pedal
  • Expression input (Please note that the Kliptonite will only work with the Stone Deaf EP-1 expression pedal because it uses the same proprietary custom components.)
    Wah Wah function via expression using thin Q setting and maximum boost.
    Phaser function via expression using thin Q setting and maximum cut.
    Tone control function via expression using medium to fat bandwidth setting and maximum boost.
  • 9v Power supply centre negative 2.1mm Boss Style (use isolated power supply only to reduce noise) Current Draw is 55mA. Please note non-isolated power supplies will induce large amounts of noise / hum.
  • Foot-switchable channel selection of overdrive and fuzz.
  • Please note if you are trying to match the volume of other pedals you need to balance out the volume by adjusting the balance control, cut / boost control and the frequency control.

SUGGESTED SETTINGS

kliptonite3.jpg

Note: This User's Manual is adapted from the official manual created by Stone Deaf FX in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline