ASRock USB 3.0 Card Quick Guide

I. Introduction

ASRock USB 3.0 Card allows you to enjoy the high speed data transfer rate up to5.0 Gb/s, which is ten times faster than current USB 2.0 device (480 Mb/s). Withtwo USB 3.0 ports on ASRock USB 3.0 Card, you can have a more flexible optionto upgrade the USB data transfer rate for your motherboard. Therefore, on thisbasis of the advantageous data transfer speed and the facilitating mobilecapability, USB 3.0 may replace other devices to become a trend for external interface.

asrock-usb3.jpg

II. Installation

Before you install ASRock USB 3.0 Card on your motherboard, please refer to below steps carefully.

  • Step 1. Insert ASRock USB 3.0 Card into PCIE slot on ASRock motherboard. Please make sure to disconnect power supply before installing or removing ASRock USB 3.0 Card.
  • Step 2. Boot your system and install ASRock USB 3.0 Card driver from ASRock support CD. ASRock USB 3.0 driver is located in the following path of ASRock support CD: ..\Drivers\USB3.0\NEC\Win7-64_Win7_Vista64_Vista_XP64_XP (v10170)\NECEL-USB3-Host-Driver-10170-setup.exe
  • Step 3. Restart your system. Then you can freely enjoy the convenience of ASRock USB 3.0 Card.

  • Whether USB legacy can work depends on the system motherboard BIOS support.
Note: This Quick Guide is adapted from the official manual created by ASRock in PDF format, without modification of the content. We just rewrite the PDF, into responsive mobile friendly pages.So, you can read this document anytime and anywhere.

Similar Manuals

you're currently offline